The front wheel stud on a 1992 Chevy Blazer S10 can be changed by jacking the vehicle up, removing the wheel, and unbolting the caliper. The rotor assembly can then be removed, and the wheel stud pressed or hammered out of its seat.
Remove wheel, brake caliper, brake disc, parking brake shoes etc. Drive out broken stud, replace with new stud. Replace above in reverse order.
Did it on a 4Runner at a Firestone Tire Shop. They charged my $15 for the part and $50 Labor. Rear wheel.
Are you asking about a wheel stud or exhaust stud, please clarify
HOW DO YOU CHANGE FRONT WHEEL STUDS ON A 1995 CHEVY LUMINA AUTOMOBILE?
Drive the old broken wheel stud out, and drive a new one in. Purchase the new stud at any auto parts store.
Does anyone know if there is a cut out to allow removal and installation of new wheel stud on a 2005 nissan altima? thanks Robert
The hub will need to be removed and the stud pressed or drilled out to be replaced.
Take tire off pound out they have splines that press fit and replace, when you bolt tire back on it will seat the new one, make sure it sticks out as far as the rest.
to replace a wheel stud, depend on the type of car or truck, jack it up and block it. remove the affected wheel and use a hammer and a punch to drive out the broken stud. most automobiles have an access hole to replace studs with out removing any more components. however some do not. to install place stud in hole and use some washers and a lugnut to mount in place.
Drive out the old one with a drift and a hammer and press in a new one. You can buy a new wheel stud at most auto supply stores.
Same way you remove any wheel stud. Hammer and appropriate punch. Sometimes a good solvent for the really difficult ones!