**Removing the old EGR valve**
1. Disconnect the Exhaust Gas Recirculation (EGR) valve:
§ Disconnect the vacuum line.
§ Disconnect EGR tube nut.
2. Remove the EGR valve:
§ Remove the two bolts.
§ Remove and discard the old gasket.
**To Install the new EGR valve**
§ Install the new gasket.
§ Install the two bolts. Tighten the bolts to 18 ft. lbs. (25 Nm).
3. Connect the Exhaust Gas Recirculation (EGR) valve:
§ Connect EGR tube nut. Tighten the nut to 37 ft. lbs. (50 Nm).
§ Connect the vacuum line.
4. Carefully clean both sealing surfaces and install a new EGR valve gasket. You're done!
location and replacement of pcv valve and egr valve on 2005 Ford Taurus se
Contact your dealer.
This issue is typically caused by a broken or jammed EGR (Exhaust Gas Recirculation Valve). To remedy the problem, you must remove the old EGR valve and replace it. Attached is an Article from AutoZone on how to determine if it is the EGR valve and how to replace the EGR on a Generation 3 (1996-1999) Ford Taurus, It will also determine if your problem lays in other EGR components.
How do you replace the EGR Valve on a 2001 Ford Escape?
do you have the 3.0 V6 12 valve engine, or the 3.0 V6 24 valve DOHC engine? 3.0 v6 12 valve
Yes, it does have an EGR valve.
insufficient egr flow most causes a burned silicone hose to egr pressure sensor
in ya mum
it is beyond the main throttle body. it is round about the size of a tangerine. it is black on my car.
just unbolt the valve
Directly behind the intake manifold.
Directly behind the intake manifold.