Want this question answered?
The 1998 Oldsmobile Intrigue turn signal flasher control module is below the dashboard on the drivers side of the passenger compartment. The signal flasher control module should be labeled as such.
how do you replace a wiper control module in dodge 1998
Behind the glove compartment.
The control module for the blower motor is under the glove box inside the heater box.
Check heatertreater.net for diagnostic information and a fix for the blend door/actuator problems endemic to this model.
Something called a blower control module takes the place and is found in the hole where you would find a blower resistor, so there isn't a blower resistor in that vehicle. As far as the blower control module is concerned, the module is serviced as a unit. No part can be fixed or replaced. This is not to be confused with the control head in the dash. The blower control module is held into the heater box with two 8mm screws outside the firewall under the hood, where you would normally find the blower resistor pack.
Replace blower control module. Usually the fan starts acting erraticaly and eventualy just stops.
Remove the radio/heater control module. Disconnect the temperature control cable at the base of the control assembly . It is on the center mound just to the right of the gas pedal. Take the heater control cable off of the back of the heater control module. Pull the temperature control cable off.
the fan has a high amp draw roasting the control module replace them both!!
UNDER THE COIL PACKS
dealer
Behind the glove box.