Trying to replace passenger side tailight on a 2002 Jeep Liberty. Cannot disconnect the plug and the replacement connector looks different from the original! Thanks Jim
replace rear tail light bulb
The 2006 Jeep Liberty rear tail light lens does not come off. The tail light is seal. You can access the tail light lightbulb through the back of the tail light, in the cargo compartment.
Tail light lens, or assemble.
take the screws out if the tail light and pull the old one out
Check the fuse, it is a separate fuse for the right and left side as well as for the tail light and turn signals.
you don't replace the tail light you just replace the bulb in it
Is your tail light out? Is the relay good? Replace the bulbs in your tail lights, should cost about $4. If that does not do it, go to your local parts store and buy a new relay. Rarely a bad switch.
there are 2 torx head screws that hold the tail light on. you will need to open the back gate to get to them. then there are two snap connectors that hold the tail light to the body. you will need to pull straight back torward the rear of the jeep to get these to come loose.
On a 2012 toyota Highlander, How do you replace tail light Assembly
you can take the tail light out by unscrewing the wing nuts in the trunk, when all wing nuts are off pull the tail light out then take the light bulbs out to replace the tail light.
Remove tail light housing. Remove lamp. Replace lamp. Replace tail light housing.
You can not, you will have to replace the entire tail light.
I ordered mine on Sunday the part cost $33.00 including S&H from Quadratec.
There are a few locations as of 2014 where you can buy a 2000 Jeep Cherokee bulb holder for the tail light. This can be purchased at Parts Geek, Jeep, and Auto Zone.
How do you replace a broken tail light cover for a 2005 Nissan Pathfinder ?
Have a look at this link: http://www.wikihow.com/Replace-a-Tail-Light-on-a-Dodge-Grand-Caravan
the tail light is screwed in from the inside of the bed of the truck
Rear lighting: Tail/Stop Lamp
Begin by removing the wiring harness to the back of your tail light. Remove the tail light assembly retaining bolts. The tail light will come off. Reverse the process to install your new tail light.
Open the trunk. Loosen the black thumb latch wing nuts that hold the tail light assembly in place. pull the tail light assembly out. You should be able to acces the tail light bulbs to replace them.
2006 Jeep Liberty tail light bulb lamp replacement: Purchase the correct replacement tail light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the tail light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Open trunk, locate inside of tail light, unscrew thumb screws behind tail light. Pull out tail light. Be careful not to drop it. Keep one hand on the outside of the tail light.