take the screws out if the tail light and pull the old one out
To replace the taillight on a 2009 Jeep Patriot, first, open the rear hatch and locate the access panel on the interior side of the taillight assembly. Remove the screws or fasteners holding the taillight in place and gently pull the assembly out. Disconnect the wiring harness from the old taillight, replace the bulb or the entire assembly with a new one, reconnect the harness, and reattach the taillight with screws. Finally, test the new taillight to ensure it works properly.
You have to remove the taillight assembly. When you open the lift gate there is 2 push clips (black round) that keep it in place. To remove the clips, you have to pull sort of hard. Then slide the taillight out of the slot that it clips into. Don't be afraid to pull the taillight, it's in there pretty tight even after the clips are removed. Twist the light bulb that needs replacing to the left and insert your new bulb.
BE sure to replace rear side marker lamps (194) in upper side of each taillight lens..They are hard to see and I had the same problem. Replaced both ( one on each side) and failure report cleared.
four screws, one in each corner of the lens
To remove the taillight cover on a 2004 Jeep Liberty, start by opening the rear hatch and locating the screws securing the taillight assembly. Use a screwdriver to remove these screws, then gently pull the taillight assembly away from the vehicle. Disconnect the wiring harness by pressing the release tab and pulling it out. Once detached, you can access or replace the taillight cover as needed.
how do you replace a turn signal bulb on a 2004 jeep liberty. I can not find screws or a panel to go through
Open up your tailgate and on the sides of the taillights will be screws, you need a Allen wrench or Allen type screwdriver. Unscrew them and pull out the taillight assembly (use a little muscle it'll come out,don't drop it) there you will find the bulb sockets gently twist out and replace the bulb ( the bulb number should be on the base,use this for replacement bulb) reinstall the taillight and put the screws back in. NOTE: the driver side access to the screws are a little tight and the passenger side is completely visible when you open the tailgate (2 screws per tailight )..
wjjeeps.com . they show how to replace every light and with what bulb
To replace the headlight bulb in a 2007 Jeep Wrangler, start by opening the hood and locating the back of the headlight assembly. Turn the bulb socket counterclockwise to remove it, then pull out the old bulb. Insert the new bulb without touching the glass, as oil from your fingers can cause it to burn out prematurely. Finally, reattach the socket by turning it clockwise and close the hood.
To replace the brake light on a 2007 Jeep Commander, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips securing the tail light, then gently pull it away from the vehicle. Disconnect the wiring harness and remove the old bulb by turning it counterclockwise. Finally, insert the new bulb, reconnect the wiring, and reattach the tail light assembly.
replace rear tail light bulb
Open the rear hatch. you will see 2 screws on the side of the taillight. Remove them and pull the taillight out.