0
To replace the clutch brake on a peterbilt you have to remove the inspection cover on the bottom of the bell housing. You then have to determine whether you have a two piece or a one piece clutch brake. If it is original it is probably a one piece. A one piece will have to be cut off usually with a torch. Be careful because very hot grease can fall in your face. A two piece clutch brake has a hinged side and a push lock on the other. the side with the push lock can usually be released with a screw driver. If the transmission is not removed a two piece clutch brake will have to installed on the input shaft.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is the cost to replace a clutch in a peterbilt?
At my shop with clutch and laber it would cost about 1,800
Where is the brake light switch on a 1995 Peterbilt 379?
Should be to the left of the clutch pedal.
How do you replace a Peterbilt windshield?
Need to know WHICH model Peterbilt in order to answer this.
Where is the brake light switch located on a peterbilt 359?
On the brake pedal itself.
Where is brake light switch on peterbilt?
It's attached to the brake pedal arm.
Where is the clutch master cylinder located and how do you replace it in a Ford Escort LX 1993?
Shared with the brake fluid.
How do you remove and replace levers on a dirt bike?
Remove the bolt in the lever perch. For a clutch lever, loosen the cable enough to remove the broken lever and replace the new one. Adjust the clutch cable back and replace the bolt in perch. For the brake (disc brake)) lever, you simply remove the bolt and replace lever, put the bolt back in the perch and you're done. If you have drum brakes, it is the same as the clutch lever routine.
What clutch fluid is used in a Jeep Wrangler?
Dot 3 Brake fluid for Clutch master cylinder.ANSWERTurn the engine off before opening the hood.Find the clutch fluid reservoir. It's usually close to the back of the engine, near the brake fluid reservoir.Take off the cap.Check the fluid level. If it is not filled to the top, you will need to add brake fluid. (See "How to Add Brake Fluid to the Clutch Master Cylinder" under Related eHows.)Replace the cap tightly.
Why would my brake lights stay on with my 2001 peterbilt 379?
Stuck brake light switch, or a short to power somewhere in the brake light circuit.
What is the color of the air brake knob on a peterbilt?
Yellow for the tractor brake control valve, red for the trailer supply valve.
Where do you put clutch fluid in a 1995 ford escort?
It uses brake fluid in the brake fluid reservoir. The clutch fluid (brake fluid) is fed by the brake fluid reservoir. The clutch fluid reservoir is just beneath the brake fluid reservoir. So, add fluid to the brake fluid reservoir to fill the clutch fluid, also.
The hydraulic brake system controls?
Brake, emergency brake and the clutch
