answersLogoWhite

0


Best Answer

First remove front axels, then remove the transmission, undo clutch bell housing. Add on new clutch pressure plate.....new clutch bell housing......put the transmission back in and axels

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace a clutch on a 2001 Ford Focus SE?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where does the clutch fluid go for a 2001 ford focus?

On a 2001 Ford Focus : The brake fluid reservoir is used for the brake and clutch systems


How do you replace water pump on a 2001 Ford Focus?

how to replace water pump on 2001 ford focus


How do I replace Ford Focus serpentine belt?

I need daigram of 2001 ford focus se serpentine belt


How do you install front wheel bearings on a 2001 Ford Focus?

How do you replace front wheel bearing on a ford focus


How do i replace the slave cylinder in a ford focus 2001?

By going to a garage


How do you put on a fan belt on a 2001 Ford Focus?

See the answer for "How do you replace the drive belt in a 2000 Ford Focus?". The procedure is the same.


How can you make a clutch adjustment on a 2001 Ford Focus SE?

I believe that a 2001 Focus will have a hydraulic clutch. If so, there is no adjustment required... In other words, or to add, if Your clutch is catching very high up, you may need a new clutch. Check hydraulic fluid if catching very low.


How much does it cost to replace airbags in a 2001 ford focus?

About $1000 each.


What should it cost to replace a clutch on a ford focus 2001?

I had it done about 3 years ago for $750, which was the best of three estimates. Sorry that it's been a while, but maybe that will gove you a ballpark estimate.


How do you replace the headlight assembly located on a 2001 Ford Focus?

There are 4 screws that hold it on.


How much does it cost to replace an alternator for a ford focus 2001?

Material and labor... about $400.


How do you replace a 2001 ford focus heater core?

You have to take half the car apart to replace the heater core