answersLogoWhite
Clutches and Flywheels
Ford Ranger
Mazda MX-3
Fuel Economy and Mileage

How do you replace a clutch on a 92 mx-3?

787980

Top Answer
User Avatar
Wiki User
2015-07-15 21:05:35
2015-07-15 21:05:35

check out this link, mx-3.com/95 manual .... It,s the complete shop manual for the 95 mx3, it should have the info you need.

1

Related Questions

User Avatar

Keep It Simple Stupid. Take it to a mechanic and replace clutch cause any clutch problem means you need to replace it!

User Avatar

the clutch is hydraulic, that means no adjustments

User Avatar

Unfortunately, you have to remove the transmission.

User Avatar

Call the Kumlord, 586-914-2039

User Avatar

you have to open the hatch, take all the plastic interior apart, just to get to your bulbs. its a pain.

User Avatar

what size is the motor 1.8 liter

User Avatar

This car does not have a spotlight.....

User Avatar

The value of a clutch plate depends on whether it is new or refurbished. It can cost anywhere from 50 to 300 dollars.

User Avatar

yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.

User Avatar

The last year the mx-3 was mad was 1996.

User Avatar

If you are not experienced or very mechanically inclined this will be hard. Start out by getting a Haynes Or Chiltons, then follow the direction. You have to take the transmission out,then remove and replace the clutch. It is not as easy as it sounds, and the tranny is heavy.

User Avatar

if manual clutch, if auto it can be the transmission. same for any other car, my mx3's clutch gave out, all that happened is i rolled, turned off the car, pumped the clutch pedal for 10 mins, and off we went. but if motor is not still running, it can be a number of things

User Avatar

Replace clutch cable on sportsbike

User Avatar

FOR ME THERE IS NO WAY TO BLEED A CLUTCH ON A SATURN BUT IF YOU REPALCE ONE PART SOMETIME ITS POSSIBLE. 20 % CHANCE .THE ONLY WAY ITS TO REPLACE THE SLAVE AND THE CYLINDER AS A SEALED KIT

User Avatar

it is inside your distributor.I have 1994 mx3 an my igniter quit,and i had to replace the whole distributor. not cheap.

User Avatar

1. Clutch fluid is brake fluid. 2. The fluid used for your clutch master/slave cylinders is pulled from your brake fluid reservoir.

User Avatar

it uses the "extra" fluid from the brake reservoir, so just check that you are ok on brake fluid and your clutch should be fine

User Avatar

There is not any adjustment on this clutch. Al you have to do is bleed the system.

User Avatar

what is cost to replace a clutch in a BMW Z3

User Avatar

It is located on the inside of the distributor . Three pin connector .

User Avatar

how long will it take to replace the clutch in my 2002 renault clio

User Avatar

you need to remove the transmission then unbolt the clutch from the flywheel.

User Avatar

Hydraulic clutch on that model is not ajustable. You either have a bad clutch slave cylinder, Or the clutch and pressure plate needs replaced.

User Avatar

how do you replace the AC compressor clutch on 2006 liberty

User Avatar

It's an automatic, there is no clutch.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.