I just had to replace the crank sensor on my 03 T&C Van. What a nightmare! If the 3.8 is anything like my 3.3 the sensor is located on the bell housing of the tranny near the seam. If you stand on the drivers side of the car and look at the engine its at about the 2 o'clock position of the housing. Hope that makes sense. Its buried waaaaay down under all that other stuff. I had to remove the battery and the battery housing and remove a couple of other things and it was still a pain to get too. Its held in by one 10mm bolt. The bolt usually isn't too tight but you may have to work a bit to loosen and remove the sensor. Then pop the new one in.
How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?
Yes
The crankshaft position sensor is on the top rear of the transmission bell housing.
The crankshaft sensor is mounted to the top rear of the transmission bell housing.
The crank sensor is mounted on the top rear of the transmission bell housing.
where is the crank positioning sensor on a 1996 newyorker van
No crank sensor, only a cam position sensor.
It is on the top rear of the transmission bell housing.
where is the crank sensor located on my 1997 Chrysler sebring lxi
Replace the crank sensor located on bell housing of trans.
top rear of bellhousing... it has a exciter ring made on the flywheel
if you have a code w/ cam to crank reference then yes. if only a crank sensor issue the no