• Auto Parts and Repairs
  • Dashboard Lights and Gauges
  • Chevy Silverado
  • Ford F-150

How do you replace a dash light in a 1984 Chevy pickup?

User Avatar

Wiki User

βˆ™ 2015-07-15 21:11:07

Best Answer

It's not easy! You have to remove the instrument bezel. (all of the screws around it) and the plastic piece on the bottom of the steering column. If you have a clock in your gauges you will need a tiny flat head screwdriver to take out the screw that holds the clock adjusting knob on. Pull the bezel out. If you can't get to the blown bulb you have to take out the clear shield. You may have to loosen some of the bolts that hold your gauges in to get to a specific bulb. Hope that helps!

User Avatar

Wiki User

βˆ™ 2015-07-15 21:11:07
This answer is:
User Avatar

Your Answer


Related Questions

How to Replace ignition switch 1984 Chevrolet pickup?

Where can I download instructions for replacing the ignition switch tumbler on a 1984 chevy pickup?

What is the Tire size for a 1984 Chevy s-10 pickup?

What is the tire size for a 1984 chevy s10 pickup

Where is tail light and dash light relay 1984 Nissan pickup?

where is dash light and tail light relay on 1984 nissan pickup truck

Where to find hidden vin on 1984 Chevy pickup?


What is the wheelbase for a 1984 short bed Chevy pickup?


How much labor to replace engine in a 1984 Chevy c60?

labor time to replace engine in a 1984 chevy c60

Where can one find reviews about a 1984 Chevy C10 Custom Pickup Truck?

One can find reviews about a 1984 Chevy Custom Pickup Truck on Kijiji. On Kijiji, one can find reviews of almost anything, including big pickup trucks.

Why wont the panellights come on on a 1984 Chevy s10 pickup truck?

The panel light dimmer switch is turned off. The panel light fuse is blown. The panel light bulbs are blown out.

Where can you find wiring diagrams for 1984 Chevy scottsdale and 1987 wrangler pickups?

where can i find wiring diagrams for a 1984 chevy scottsdale, and a1987 wrangler pickup?

Can 23 inch rims fit on a 1984 Chevy s10 pickup truck?


What is the wheelbase a 1984 Chevy pickup?

Check this url it will give you all specs.

How do repair the fuel lines in a 1984 Chevy pickup? has online manuals that give step by step how to

Does anyone have a copy of the wiring diagram for a 1984 and a1985 Chevy S-10 Pickup?

no we don't

How do you replace vacuum actuator on a 1984 Chevy blazer?

on the front axel

How do you replace a fuel filter for a 1984 fuel filter on Chevrolet S-10?

How to replace a fuel filter on a 1984 Chevy S-10

What socket is needed for the front axle nut for the hub assembly on a 1984 Chevy pickup?

A 11/16 socket is needed to remove the 1984 Chevrolet pickup front axle hub assembly. The socket should be a five-point socket.

How do you repair a loose and sloppy steering in a 1984 Chevy truck?

replace the worn parts.

Where is the vacuum module located on a 1984 Chevy pickup transmission?

rear drivers side of tranny,likely a 700-r4 trans

The coil keeps going out on a 1984 Chevy pu 350?

Next time you replace the coil, test and if necessary replace the resistor.

Why are there 3 extra holes on the new power steering pump for a 1984 Chevy pickup?

Perhaps it is designed to fit multiple years and/or models

Where is the oil sending unit on a 1984 Chevy pickup?

It is screewed into the top of the engine block right behind the distributor. It is hard to get to. Real trickey.

84 Chevy pickup coolant sensor 6 cly location?

where is the coolant sensor on a 1984 s10 blazer 2.8 6 cylender

How do you replace the water pump on a 1984 Chevy Caprice 305?

One of the easiest but to do it right , get a manual on your car.

Why did your choke light come on in your 1984 El Camino?

The choke light on a 1984 Chevy El Camino will come on if the choke fails to open or close. The choke should be visually inspected to verify functionality.

Will a steering column from an automatic transmission 1979 Chevy pickup without tilt wheel fit in an automatic transmission 1983 Chevy pickup with tilt wheel?

yes 1973 to 1983 will work because this is before 1984 when wipers moved to the column in the full size trucks. it will bolt right in directly. good luck