0
What else can I help you with?
How do you change the ignition coil on a chrysler Sebring with the 2.5?
You have to replace the distributor assembly.You have to replace the distributor assembly.
Will a Chevy HEI distributor replace a pontiac points distributor?
no
How do you replace the ignition distributor on a 93 mx6 v6?
How do you replace the ignition distributor on a 93 mx6 v6 pics?
How do you replace a camshaft sensor on a 1999 Tahoe?
The cam shaft position sensor is located under the distributor cap. You can replace this easily by undoing the screws holding on the distributor cap, remove and replace the sensor, then just replace the distributor cap.
Where is the camshaft position sensor on a 2001 Daewoo matiz?
On the 2000 model it is part of the distributor and you either replace complete distributor or try to dismantle the distributor and replace sensor only.
How do you replace the camshaft sensor on a Chrysler Sebring 1996 2.5l v6?
The cam sensor is part of the distributor. You have to replace the entire distributor.
My 95 Nissan altima keeps stopping on me after 15 minutes i replace the ignition module the distributor cap the distributor roder and the fuel filter?
the faulty part is actually located in the distributor so you need to replace the whole distributor
Where is the cam position sensor on a 97 Nissan pickup?
It is part of the distributor. You have to replace the distributor
How do you replace the magnet under the distributor on a 1992 Chevy blazer?
buy a new distributor
Location of cps on 1999 Honda civic?
Inside the distributor. Replace the whole distributor.
How do you replace the distributor cap and rotor on a 1998 Toyota RAV4?
there is no distributor on a 98 rav. therefore no cap or rotor. replace the plugs and wires and the tuneup is done
How do you replace the distributor on a Nissan pickup D21 1996?
To replace the distributor on a 1996 Nissan D21 pickup, first disconnect the battery and remove any components obstructing access to the distributor. Mark the position of the existing distributor and the ignition wires for reference, then remove the distributor cap and rotor. Unscrew the distributor hold-down bolt, lift the distributor out, and install the new one in the same position. Reconnect the ignition wires, replace the rotor and cap, and reconnect the battery to complete the installation.
