in order to replace the handle, you must first take off the door panel. This will require a torque bit. ( kind of looks like a star ) to remove the panel you need to remove all the screws around the bottom of the door. Then isung a flat bladed screw driver, pop out the central door grip, and the screw tab behind the interior door handle. remove those screws. now just lift the panel straight up.
Next you have to remove the foam padding. this is easy, it should just pop off the clips that are holding it.
next you need to remove the liner from behind the door handle. note (don't completely remove the liner, you still need to put it back.) all that's left is to remove the screws holding the handle to the car. ( if your replacing the entire assembly then remove both screws.) if you only need to install a new handle, just unscrew the left screw, ( this is the screw that you need to take the rubber seal off of the door to get at.) that will release the guard over the key hole. remove the guard then pull the handle sideways towards the lock. It should release. (if your handle broke, then the procedure is reversed.)
Finally all that's left is to re-install everything.
good luck. hope this helps.
Remove the door panel.Remove the bolt from the inside of the door that holds the handle on.
You can replace the inside drivers door handle by removing the door panel. With the door panel removed the door handle mechanism will be visible. Remove the linkage from the door handle. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
Its on youtube
Remove the door trim panel. Remove the inside door handle rod. Remove the inside door handle retaining rivets. Remove the inside door handle from the door by sliding the handle rearward.
Start with removing the door panel.Now you can see the specific connection from the handle to the linkage.See "Related Questions" below for more
On the focus the connections for the door handle can go bad...the trick is to push down on the door handle while pulling out on it.
To replace interior Ford fusion door handle you must remove the door panel, take off the old handle and replace with the new one, and then replace the panel back on the door frame.
hi please show how do i replace the Toyota seinna 2000 front handle door thanks Andy
You can get a diagram for your 2000 Dodge Caravan rear door hatch handle and most Dodge dealerships. Your local library will have Dodge service manuals with the diagram.
how do I replace the inside door handle on a 1998 chevy cheyenne?
youll need to take the door panel off, then unscrew the handle assembly and replace with a new handle ( junkyard?). screw that in then replace door panel.
Inside door handle or outside door handle?