Want this question answered?
There is no fan belt on a Mazda Miata.
The camshaft position sensor on a Mazda Miata is changed by disconnecting the wiring harness and unscrewing the sensor using a wrench. The threads can then be cleaned and a new sensor torqued into place.
See related links below for location. Unclip harness, remove 10mm bolt, remove sensor.
The 2000 Mazda Miata O2 sensor bank 1 is located on the firewall in the engine compartment. The sensor can be found on the passenger side of the firewall.
how to replace window motor ion 91 madza miata
On a 1999-2005 model Mazda Miata the camshaft position sensor is located on the valve cover towards the rear of the engine (closest to the firewall). It has one 3-pin connector connected to it and one 10mm bolt to remove the sensor
Will a 1992 mazda miata hardtop fit a 2000 mazda miata?
There is no MAP sensor on a 1999-2000 Mazda Miatas. There is a boost sensor that assists with controlling the EGR Valve solenoid and a few other features, and is located on the passenger side on the lower part of the intake manifold, and says "Boost Sensor" on it. The primary sensor for monitoring incoming air and fueling is done by the Mass Air Flow sensor (MAF), not MAP (like Hondas). This is located on top of the stock air box and is a black, cylindrical tube about 6" long.
The 2003 Mazda camshaft position in sensor can be found on the back of the left-hand cylinder head. The camshaft position sensor should be labeled as such.
There are two fans on a Miata. The main fan is triggered by the coolant temperature sensor, which is at the back of the Miata engine, dead center, just above the transmission. The second fan is triggered when AC is turned on.
Is it feasible and approximately how much will it cost to replace the air conditioner in my '91 Miata with a unit that does not use freon?
Looking directly at the engine, it is the small, black sensor on the left side of the valve cover. Simply unclip the electrical plug and remove the 10mm bolt. It will easily come out.