i have never done it before, but i believe it is a similar process to replace the parking lights. you must remove the wheel well liner by removing a few bolts and plastic plugs and pulling the liner back. you should be able to replace them that way. But first i would try from in the engine compartment, the way you change your low and high beams because that would be a much easier way if you can fit your hands in there.
i have an is300 also and a got a xenon hid kit on my fog lights, they can be replaced , the bulb type is 9006 (hb4)
how to replace a fog light on a Jaguar?
Phillips 9006
how to replace a front fog light on a ford focus
How to replace fog light bulb for acura rl 2002
How do you replace the fog light located on a 2003 Ford Expedition?
How do you replace the drivers side fog light in a 1999 BMW 740il?
how do you replace the fog light bulb on a 2003 ford explorer.
replace it
You will have to access the fog light bulb from below the vehicle. Remove the plastic clips from the wheel well cover extension that is below the fog light. Once the clips are out and the plastic cover is pull down, you should be able to see the back of the fog light. You can try to replace the fog light bulb now or remove the two 10mm bolts and slide the fog light assemble out through the front of the bumper. Turn the cover of the rear of the fog light and replace light.
how do you replace a bulb in a fog light on a 2000 maxima?
To install fog light in a 2000 Trans Am, disconnect the fog light switch from the housing. Then remove the washer, bolt, and nut. Finally, remove the fog light housing, twist the fog light off, and replace. ?æ?æ