How do you replace a fuel pump on a 1997 subaru impreza wagon?
its in the boot under the carpet by the back seat undo outer cover with 4 screws then there is a few 8mm screws plus the pipes ontop of the pump but before you undo the 8mm bolts release the presure first by undoing the petrol cap.
on the end of the wiper you will see a plastic clip if you look carefully you will see it has a little clip system normall i use a little tiny flathead screwdriver or a pointed knife by pressing the under the clip this should allow the wiper to be slid off the arm, use your clip on the new wiper blade if you can.
On a 1997 Subaru Impreza When it is cold out side it will not start as soon as it warms up there is no problem starting what could be wrong?
Rear wheel bearings need to be replaced often. In areas with road salt, the rear drive shafts often need to be replaced with the wheel bearing, because of excess corrosion around the bearing seals. Rust at the back of the rear wheel arches is common after 10 years. Oil leaks from the camshaft seals on the engine after 150,000 miles. Not expensive to fix.
What are the timing marks on a 1996 Subaru Impreza or how do you set it without the use of a timing light?
1993 through 1997 Subaru Impreza all have the same car stereo wire colors (except for the power antenna lead). See this table: http://ae64.com/WRX-pinout.htm 1993 and 1994 have a manual rod antenna, so there is no pin or wire at pin 14. Front Speakers Size: 6 1/2″ Front Speakers Location: Doors Rear Speakers Size: 6 1/2″ Rear Speakers Location: Rear Doors Links to pin-outs for other Subaru models and years are here: http://ae64.com
Can you put front seats from a 1992 non-turbo Subaru Legacy L front-wheel-drive wagon in a 1997 Legacy non-turbo all-wheel-drive wagon?
Whoever wrote that you need to buy an entirely new headlight assmebely was not very well informed, nor very clever as it is very, very easy. 1) Open the hood. 2) Unplug the wire going to the back of the heald light. 3) Remove the rubber housing covering the light build, use a screwdriver to pry it. 4) There is a little spring (vshaped that starggels around the back of the bulb) that hold the…