answersLogoWhite

0

You remove the door panel, remove the screws or bolts holding the old one in, unplug the wire and throw the old one in the nearest trash can. Plug the wire into the new one, re-install the bolts and door panel. About an hour job.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

How do you adjust the drivers window of a 98 Geo Metro that will not roll up straight?

replace window regulator


How do you replace the window crank handle on a 93 Geo Prism?

To replace the window crank handle on the 1993 Geo Prism, first remove the interior door panel. Then, access the screw that holds the window crank in place and remove it. You can then remove the handle itself.


How replace a motor mount on a 1997 geo prizm?

Remove the old mount & replace with the new.


How do you change the power steering hose on a 93 geo prism?

How do you replace power steering pressure hose on a 1993 geo prizm


How to fix driver side window on Geo Metro 1997?

To fix the driver side window on a 1997 Geo Metro, first, remove the door panel by unscrewing any screws and gently prying off clips. Check the window regulator and motor for any damage or disconnection; replace or repair them as necessary. If the window is off its track, realign it and ensure it moves smoothly. Finally, reassemble the door panel and test the window for proper operation.


How do you remove and replace the left side power window mechanism including cables on a 1994 GEO Prism?

You gotta take off the door panel. The rest should be obvious once you do this.


How do you replace the motor mounts on a 1993 Geo Metro?

Begin by loosening the motor mount retaining bolt in your 1993 Geo Metro. Jack the engine up a few inches. Remove the retaining bolt and the motor mount bushing. Put the new bushing in and reverse the process.


What do you do you do your oil pan gasket is leaking on your 91 Geo Prizm?

umm if it was me i would just replace the motor that gasket is way to expensive to have replaced it costs like (10.00) so i would just replace the motor!!!!!


How do you replace power steering fluid 95 Geo Metro?

To replace power steering fluid on a 95 Geo Metro, open the hood. There is a large yellow knob labeled with powering steering fluid only. Drain the old power steering fluid and place new fluid.


How do you put the window back on track on a 1996 Geo Metro?

To put a window back on track in a 1996 Geo Metro, the door panel will have to be removed. Use a screwdriver to pry up the clips around the door panel. Then locate the window cable and rewind it. If the window is operated by a power switch, be careful not to pinch the fingers when rewinding the cable.


Can a 1996 Geo Tracker motor replace a 1995 Geo Tracker motor?

if 16v ? yes. the 96 to 95 direct (long block yes, not manifolds) 95 to 96 , you must swap oil pump and pan. with CKP sensor. see my profile links.


How do you replace a heater blower motor in a 1994 geo prism?

To replace the heater blower motor in a 1994 Geo Prism, first disconnect the battery to ensure safety. Remove the passenger side lower dashboard panel to access the blower motor. Disconnect the wiring harness and the mounting screws securing the blower motor, then carefully pull the old motor out. Install the new blower motor by reversing the steps, ensuring all connections are secure before replacing the dashboard panel and reconnecting the battery.