You gotta take off the door panel. The rest should be obvious once you do this.
Remove cables from battery Remove + cable from the starter solenoid Remove the - battery cable from engine ground install new cables using the same routings as original
To replace the battery cables on a 1999 Mercury Mountaineer, loosen the connectors at the terminals. After this, remove the other end of the cables and install new ones.
Disconnect the car battery cable, remove the spark plug cables, remove the spark plug boots, and remove the old spark plugs. Next, put in the new spark plugs, replace the boots and cables and reconnect the battery cables.
Disconnect the battery, remove the cover, remove the cables and boots, and remove the spark plugs. Put in the new spark plugs, replace the cables and boots, replace the cover and connect the battery.
Remove the seat, remove the cables replace the battery. reinstall everything.
It is important to replace old spark plugs to keep a car engine running well. To replace them disconnect the battery, remove the cables, remove the old spark plugs, replace with the new spark plugs, replace the cables in the correct order, and connect the battery.
First, take the battery cables off then remove the battery hold down then remove the battery. Reverse order to install. Be sure to clean the cables.
Disconnect the battery, remove the air hose to the throttle body, remove the access plate, remove the spark plug cables and the boots, and remove the spark plugs. Replace the spark plugs, replace the boots and cables, replace the access plate, attach the air hose to the throttle body and connect the battery.
replace gear shift cable citroen dispatch
disconnect neg bat terminal , remove belt , remove cables from alt. , remove bolts holding alt.
Disconnect the battery cables, remove the spark plug cables and covers, and remove the old spark plugs. Next, put in the new spark plugs, attach the covers and spark plug cables and reconnect the battery cables.
You will need to go under the hood first to remove the gas tank. Then you will need to go under the deck and remove 2 pins that are near the cables. After you remove those pins, there are some clips that need to be removed and a couple of ties. You then can remove the cables to replace them.