Want this question answered?
for the removal, pull of the upper radiator sight shield, make sure that the headlamp switch and the ignition switch are turned off, raise the headlamp assembly retainers by pushing rearward and then pulling up to save time. disconnect the headlamp assembly wiring harness and remove the headlamp assembly, install just do the reverse.
See posting for "How do you change the headlamp bulb in a 2003 Grand Prix?" All these model years are similar in production for the headlamp assembly.
Open the hood, remove the pins holding the headlamp assembly, remove headlamp assembly, now you can reach in and remove the day time bulb socket assembly to replace the bulb. Repeat procedure on other side.
back of assembly and twist.
If the "side lamp" is located in the headlamp lens assembly, check out the "Related Questions" below for lots of detailed help
How do you replace the morror assembly for a 2001 Buick Regal
Open the hood. There are three hex head bolts that hold each headlamp to the van. Remove each bolt and gently pull headlamp out from grill using the small handle-like grip. The headlamp will remain connected to the van with the lightbulb socket. Twist the collar away from the bulb then pull the bulb assembly out of the headlamp. Replace bulbs and reassemble components.
Open the hood. Near the front of the turn signal assembly there is a Phillips head screw. Loosen but do not remove the screw; it releases the front of the assembly. You then need to pull forward to release the pin holding the rear of the assembly. Reverse the above to replace the assembly.
how do you replace the bulb of a volvo v70xc 2001 side mirror?
With the hood open remove the (2) two headlamp assembly bolts from the upper fascia support. Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support. (to release the tabs from the slots on the passenger side lens move the assembly to the left when facing the engine, and when doing the drivers side lens shift the assembly to the right ) Position the headlamp assembly away from the vehicle body to access the electrical connector. Disconnect the electrical connector from the headlamp assembly. Remove the headlamp assembly from the vehicle. If you wish to change the halogen bulb: Disconnect the electrical connector from the headlamp bulb/socket. Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise. Remove the headlamp bulb/socket from the headlamp assembly. . "G" These instructions are similar from around '96 to '03 grand prix model years all trim levels.
how do i replace the hub assembly on a 1997 cavalier 2.3 Ls
http://www.bombaydigital.com/boxster/projects/headlamp/