Chevy Blazer

How do you replace a hub assembly on a 1993 Chevy Blazer?

353637

Top Answer
User Avatar
Wiki User
2006-02-21 00:58:06
2006-02-21 00:58:06

unbolt the caliper and push to side gently. do not remove the brake line. take off the half shaft nut. there are three bolts holding the assembly in. remove those. you might have to make up a press to help remove the hub. take out 2 wheel studs (opposite sides and use two longer bolts with the headsagainst spindle. put nut and washer on the inside between the two with washer touching the hub side) then slowly turn the nuts to push the hub off.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Replace it with a new one, there is no repairing it.

User Avatar

Where is the horn located on a 1993 chevy blazer

User Avatar

Need to replace the ingnetion module in the distributor.

User Avatar

One at a time so as not to mess up the firing order.

User Avatar

A blown fuse can make your dashboard lights to not work in your 1993 Chevy Blazer Tahoe. A burned out bulb can also cause this.

User Avatar

which fuse is for the fuel pump in a 1993 chevy s10 blazer

User Avatar

You will need to remove the inside door panel of your 1993 Chevrolet Blazer. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new door handle.

User Avatar

The 1993 Chevy S 10 Blazer IAT sensor can be found on the top of the transmission. The IAT sensor will be near the front of the transmission.

User Avatar

Is there a way to bypass the ECM in a 1993 chevy s10 4.3 vortec

User Avatar

Behind the dash assembly inside the heater box. Dash assembly must be removed to gain access.

User Avatar

if you have to ask this question, then you shouldn't attempt to change them...

User Avatar

There is no spark plug cap located on the 1993 Chevy Blazer. The spark plug gap for this vehicle varies depending on the type of spark plug that is used. The OEM spark plug gap for this year is 0.040.

User Avatar

You can replace them in any order. Just do not forget which plug wire goes to which cylinder.. The engine is a 4.3

User Avatar

i need to find location of fuel filter on 1993 Chevy cavalier

User Avatar

by separating the lower balljoint and sway bar on that side

User Avatar

Under the vehicle, bolted to the frame on the driver's side

User Avatar

The ecm would be in the passenger side kick panel.

User Avatar

You will have to remove the door panel and replace the regulator assembly. In some cases it comes as an assembly with the motor.

User Avatar

It has 1 big hub bearing per side and you can not service them. It has factory sealed bearings. If there bad then you must replace the bearing.

User Avatar

these transmissoins will not interchange. To be sure I would call a salvage yard and ask them; they have a HOLLANDER exchange and they can tell you for sure.

User Avatar

It takes 30 gallons of gas to fill up a 1993 Chevrolet Blazer 1500. Features of this vehicle include power steering, and a manual transmission.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.