Want this question answered?
If, after close inspection you do not see any damage to hub, you can use it. But ALWAYS install new bearing race with bearing.
A wheel bearing is pressed in to the hub so that it is able to safely operate. To replace a bearing on a Chevy Impala remove the hub from the car and take the unit to a machinist. Have the press out the old bearing and press in the new one.
It's a sealed unit with the hub. You have to replace the whole hub assembly.
taking out rear hub asembly on a 2002 Chevy ventura
idk ask a freaken car person --HARRY POTHEAD
It has 1 big hub bearing per side and you can not service them. It has factory sealed bearings. If there bad then you must replace the bearing.
Yes it can be. I think you need to replace the whole hub assembly
You can replace both... Bearing or Hub... Bearings are cheaper, but harder to find and replace. Hub assemblies are easier to replace, but slightly more expensive.
36mm. You will also need an 18 mm box wrench to replace the bearing assembly.
a hub is what the wheel bolts to on the car.the hub bearings are the bearings that allow the hub to turn on the axle. most times they are called axle bearings,
No. That is a factory sealed bearing.
The front wheel bearing is a sealed unit with the wheel hub - replace the hub and wheel bearing unit. Remove the four bolts from the rear of the steering knuckle that connect to the hub bearing unit.