How do you replace a light bulb on both turn signals for a 1995 jeep grand Cherokee Laredo?

Answer 1

if it is the front you need to take out the entire headlight assembly. if it is the rear opne your liftgate you will see three screw, take them out, replace the bulb inside i think it's the middle bulb, shouldn't run you that much..

Answer 2

For the front turn signal:

There are two ways to get at the bulb.

Way 1) YOU NEED A SKINNY SHAFTED STAR SCREWDRIVER. This is how the manual describes it: Unscrew the 2 star screws holding the parking light housing on. One is on top, the other is between the parking light and the turn signal. This second screw can be very difficult to get to because the parking light and turn signal housing are very close. After the parking light housing is off, you can unscrew the turn signal housing. The screws should be located on top of the housing, underneath the parking light housing.

Way 2) This is the way I did mine: First, you have to take the headlight housing off. It should be pretty easy to pop off if you pry it the right way. It is held on by 1 square clip and 2 ball and socket clips. There is a small risk of breaking the ball and socket clips, as getting the headlamp housing off does require a little force, so be careful. You may want to take the headlight bulb out first, but isn't necessary. (Removing the right side bulb may require removing the battery) Once the headlamp housing is off, the turn signal bulbs should be very easy to get to.

To remove the bulb, simply turn the bulb socket and it will come out.

For the rear turn signal:

Open the lift gate.

There are 3 hex screws that hold each rear light assembly on. I'd recommend a hex screwdriver, as a socket wrench or box wrench would be very hard to use on the screws. Once the hex screws are off, just tug on the light assembly and it will come off. The bulbs are very easy to get to. The turn signal is the yellow one.

Answer 3

open hatch. remove the screws and pull tail lamp straight back. for the back turn signals. the front remove screws and pull forward.