Yesterday, I replaced the driver's side map light in my own '99 Intrepid. There are two metal clips that have been snapped into place on the top (hidden) side of the map light fixture. Grab either side of the fixture and pull down. (Use your fingers if you can and try using your knuckles as a fulcrum on the interior ceiling to avoid pulling down too far. The metal clips are no more than 1" in length.)
Once open, you'll see both lights snapped in. Dislodge either by pinching the plastic on either side of the bulb. Once open, replace your bulb and reassemble.
Finding a #192 bulb though might be your most difficult challenge. I wound up ordering one from an auto supply store for $1.49 plus tax.
Good luck!
I was wondering this also and just did mine. YES, you have to grab the entire light assembly and pull down, as there are 2 of those metal-into-plastic clips that hold it in place. Then just unsnap the socket(s), change the bulb(s) and snap back in.
I think the bulbs are 194 types, which are all over most stores, even Walmarts. 194LL is a longer life replacement.
where is fuel line located on 1999 dodge intrepid
Trunk light switch is part of the trunk light socket assembly...
No. A 1999 Dodge does not have a reset switch.
No
Yes, 2nd Generation Intrepid was made from 1999 through 2004 IDENTICAL Cars Actually, it was 1998 through 2004.
A Dodge mechanic.
in the trunk there are 3 plastic wing nuts take them off and the light will come out.
1999 dodge intrepid is not starting I change crank and camshaft sensor and it stall will not start what can i do next.
The factory amp on a 1999 dodge intrepid is located on the right kick panel behind the dash.
5w30
Yes, but you need the computer and air conditioning parts from the 3.5
Have a look at this link: http://www.wikihow.com/Replace-a-Tail-Light-on-a-Dodge-Grand-Caravan