I was able to replace the oil pan without pulling the engine. First I rented an engine host. I put the front of the truck on ramps. I disconnected both motor mounts and dropped the bell housing inspection cover. I the remove the oil filter bracket and in my case the oil cooler lines. I had to remove the bracket that the tranny lines go through. I also loosened up the supports on both sides of the engine to the bell housing. I put the engine on the hoist and raised the engine about 3 inches. Be careful not to crush the wires running up the back of the engine. Then you can remove all the oil pan bolts and with a little wiggling remove the pan. I made sure to clean the oil pump screen before installing a new gasket and oil pan.
NO YOU CAN NOT. It will not lube the engine bearings.
Right behind the distributor and it is tough to get to.
Remove engine oil pan
what would cause a oil pressure gauge to fluctuate on my 99 Chevy truck silverado i change the sending unit it does it mostly after it warmed up
what weight oil used for 2004 Chevy silverado the standered is usually 5 w 30
"Where is the oil plug located for a 2008 Chevy silverado ext cab?"
In the oil pan
5W30 oil.
How much oil does a 93 Chevy truck hold
how to replace oil pump on 1994 z28
It will be in the bottom of the oil pan.
10w30 synthetic