Remove the interior door. Here is a web site with a good description on the steps you will need. http://autorepair.about.com/od/otherodddiyjobs/l/aa092504a.htm After the interior door is removed it is pretty straight forward, just remove the nuts that attach the regulator to the door frame and attach the new one. It is helpful to have a second person to hold the window up while you are working.
REMOVE AND REPLACE SWITCH AND CRIMP THE CONNECTOR TO THE SWITCH.
I haven't done this, but I think that plastic trim piece in the corner of the window pops out to expose the fasteners that hold the mirror housing. A body shop can tell you how to replace the mirror and/or motor.
Remove the inside door window panel. Make sure the window is on the window track. Make sure the window linkage is not needing repair. Replace the window motor.
On Camry 99 it took me 20 mins to replace the right side. The drivers side take about the same time.
We had a 1996 Camry. The window activation constantly blew a fuse for the speedometer, dash lights, etc. My mechanic said over the phone that it was a wire short in the drivers door, and sure enough, that was it.
You normally gain access to the bulb from inside the trunk.
I need to replace my outside handle on the drivers door. Toyota told me to go on line to see a diagram. But, where? It is a 2000 camry.
Where is the circuit breaker for power window in 1990 camry?
Search Browse FAQ's for the answer to this question: In 2000 Camry power mirror replacement is it necessary to remove the door panel or is the connector wire long enough to pull the connector end up and any pitfalls in panel removal?
go to the website autorepair.about.com and they have the step-by-step instructions. good luck!
The power windows on a 1999 Toyota Camry's driver's side window may not roll up if the fuse or motor are bad. You should replace the fuse or take it to a local dealership for diagnosis.
For that you will have to remove the whole window mechanism. Then you will be able to replace the motor. When you assemble the mechanism make sure that you have set up position of the gears properly.