i had to do this a few days ago all u really have to do is first drain the coolant, then move the intake out of the way , there are three screws hold it down.after that there is a hose that was kinda under the intake you need to remove that so you can get the cooling fan out once you have that done you have to remove the cooling fan there is a screw on the right side of it the rest of the cooling fan just pops out(DO NOT REMOVE THE HOSES that may get in the way of removing the cooling fan those are to ur ac so un less u don't want that to work the don't do it). then u need to get under and remove the plastic covers that protect the radiator there are some scerw behind the radiator u need to remove these cause they stupidly attached the ac cooler thing to the radiator . after u remove thos u should be fine. there are also some screws and up at the top of the radator that keep it from move around after u remove those and the last hose that's connects to the radiator it should just pull out. after that u just put the new one in and put every thing back.
how to replace a radiator in a 1996 buick regal
ck
In front of the radiator between the grill and the radiator
The thermostat is usually located on the lower hose, where it attaches to the radiator
how difficult is it to replace the MS on a 1996 Honda accord
peice of cake man,especially being manual,remove the fan that is held on with one ten mm bolt than the hoses and pull her out of there.
YES BUT. YOU SHOULD USE THE 1996 CRANKSHAFT AND THE 1996 INTAKE SO YOU NEED TO DISASEMBLE BOTH ENGINE TO DO ONE
Yes! both the radiator and the hoses are swapable :) Just besure that if your vehicle has a automatic transmission the radiator has the automatic transmission cooling line fittings.
replace your radiator cap...
Solenoid going bad remove and replace starter assembly.
Inside the fuel tank.Removal of the tank is necessary to replace the pump.
Call or contact Radiator.com on the web. Great products and service.