answersLogoWhite

0


Best Answer

The bumper COVER can be replaced very easily with the correct tools (the actual bumper is located underneath the bumper cover). I used a torx driver, a Phillips and and two small sockets to remove my bumper cover. On a 2001 Tribute there are two screws in each of the wheel wells, one at the top of the bumper cover and one at the bottom that you need to remove. Then remove the four torx screws located under the lift gate and the bolts holding on the two pads. Underneath there are 4 connectors that are removed by backing out the screw in the middle and then pulling out the connector.

Be sure that all the edges are free and you have not missed any connections.

At this point the only thing holding the bumper cover on are two guide pins on either side of the vehicle. You can remove the cover by sliding it to the rear over the guide pins until it is free (about 3-5 inches).

The actual BUMPER is now exposed and can be removed by removing the bolts that hold it on.

To replace the parts just reverse the above procedure.

Most any auto parts store can sell you a repair manual for around $25 that will show the details of how to do this and many other things.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace a rear bumper on Mazda tribute?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace rear bumper on Nissan Sentra?

how to replace rear bumper brackets on a 2002 Nissan sentra


What size rear wiper blade do you need for a 2001-2009 Mazda tribute?

The 2001-2009 Mazda Tribute takes a 10" or 11" rear wiper blade.


How do you remove rear bumper Mazda 323f?

hi just bought a mazda 323f but need to remove damaged bumper how do i do it please


Rear Wheel bearing repair on a 2001 Mazda Tribute?

The 2001 Mazda Tribute came equipped in a 2.0L L4 and 3.0L V6. The rear wheel bearing are sealed assemblies. These can be pressed in to complete the install. The OE replacement rear wheel bearings for this application are SKF #GRW266. It is recommended to replace the wheel bearings in pairs.


How do you remove rear bumper jaguar x-type?

how do you remove and replace rear bumper on an xtype jag


How do you replace the rear bumper on a 1995 Nissan Pathfinder?

you replace it


What tool it takes to repair the brakes on 2001 Mazda Tribute?

Front or rear? Drums rear?


Where is the OBD II port on a 2002 Mazda Tribute?

The 2002 Mazda Tribute OBD 2 port is on rear edge of dash; right of hood release


What Mazda cars have rear wheel drive?

Mazda RX8 is RWD Mazda Tribute is FWD but can also be bought in 4WD configuration.


How much Saab 93 rear bumper?

how much will it cost to replace rear bumper cover on 2003 93 saab


How do you replace your suburban rear bumper?

you take it to a mechanic


How do you replace 2001 aurora rear bumper lights?

The rear fog lights are accessable from under the car. You have to reach up and under the rear bumper.