Want this question answered?
Unscrew and screw in new one.
Gear shift lever, hand brake, foot brake, clutch, accelerator, choke, spark advance.
Are you asking about the shift lever on a column shift car or the console shift handle?
loosen the bolt on the lever, remove the lever and replace in the new angle, then retighten.
On my 2000 Boxster it just pulls off the lever.
Do you want to replace just the lever or the shift lever control? If it is just the lever pull the rubber cover back away from the column and you should see a pin or a screw that runs through the middle of the shifter column. Get a small punch and punch the pin out, or if it is a screw just screw it out of the column. It will probably be a star drive screw. Hope this helps.
it is not the fuse it is a broken wire. Replace the shift lever.
700r4 gear shift lever want lock in place
It is immediately in front of the gear shift lever, just to the left of the heated seat buttons. It is the one with the arrows pointing up and down. Some Z3s had manual tops and would have no switch.
Turn the knob counter clockwise to remove it and clockwise to replace it. The "boot" is more then likely attached to the console that surrounds the shift lever.
bark lever
The shift level is locked by the shift solenoid. When you step on the brake, the brake switch sends power to the shift solenoid and it moves a lever to unlock the shifter. If either the switch or solenoid is bad, you can't shift out of park.