Do you want to replace just the lever or the shift lever control? If it is just the lever pull the rubber cover back away from the column and you should see a pin or a screw that runs through the middle of the shifter column. Get a small punch and punch the pin out, or if it is a screw just screw it out of the column. It will probably be a star drive screw. Hope this helps.
Are you asking about the shift lever on a column shift car or the console shift handle?
I would replace the turn signal switch.
The fuel cap release, for a Chevrolet Tahoe, is located on the floor next to the drivers seat. Pull the lever up to release the cap.
Its right next to the, "Someone who knows about cars should be doing this" lever.
chevy silverado ha automatic transmission . shift lever on column when put in or out of gear flops up and down . is it hard to put a spring in the column to repair
The headlight dimmer switch is located on the end of the lever. Remove the steering column so the lever can be properly reached.
The transmission uses a cable for linkage. If the car has consol shift the cable runs from the shifter to the transaxle. If it is a column shift the cable runs from a lever on the column to the transaxle.
It turns out the headlight switch is not a serviceable part on the Subaru Forester. Instead, the entire turn signal lever must be replaced (a $100 part). A brief description of how to replace the turn signal lever follows: First, remove the steering column cover. There are three screws underneath - remove those. Then release the steering column adjustment lever and leave it down. The bottom part of the steering column cover unsnaps from the top part and you should be able to remove it easily. The top part of the steering column cover can just stay there and be moved as necessary to gain access to screws. Next, remove two screws where the turn signal lever assembly attaches to the steering column. Remove the electrical harness and the turn signal lever assembly should just pull straight out. Reverse the process to put in the new turn signal lever assembly.
no just the air bag wheel lock plate and lower column 2 15mm nuts hazard switch and unscrew turn lever mounted to switch phillips screws hold switch down unplug t/s harness ar base of column and pull switch while feeding the harness through the column its easy but you will learn to curse in 3 languages
dimmer switch is on the turn signal lever, to replace you need to remove steering wheel
replace the steering column.
The tilt lever should have a pair of flat spots near the column. Put a wrench on the flats and it should just unscrew.