no just the air bag wheel lock plate and lower column 2 15mm nuts hazard switch and unscrew turn lever mounted to switch phillips screws hold switch down unplug t/s harness ar base of column and pull switch while feeding the harness through the column its easy but you will learn to curse in 3 languages
pull the steering wheel
Just to the right of the steering column, close to the fire wall. Remove both plastic panels beneath the steering column to be able to see it.
Turn signal cam is broke. Remove steering wheel and replace it
In most cases you will need to replace the turn signal switch on the steering wheel for your 1983 Chevy Caprice Classic rather than fixing it. To replace it, remove the horn pad and then use a steering wheel puller and compressor to remove the steering column. You will then remove the signal along with the wiring harness and bus fuses. Replace the signal and wiring and then replace the steering column itself.
mounted on firewall left of steering column in a junction box usually black
I don't have a diagram, and I'm certainly not an expert, but I did have to locate the flasher on a 96 Lumina sedan and replace it. It wasn't easy to find even knowing where it should be. You have to remove the panel under the steering column and it will be farthest from you on the very front near the floor.
disassemble steering column,and replace signal arm ass'y
short in your turn signal switch...replace it.....check your brake lights
try going to www.autozone.com and check on vehicle specs and or components location.
FRONT SEATING AREA, DRIVER SIDE, UNDER DASH, MOUNTED ON PASSENGER SIDE OF STEERING COLUMN.
Flasher is bad. to replace it it is under the dash at the back of the steering column.
your flasher is bad replace it It's probably the turn signal signal switch in the steering wheel hub. They're junk from the factory.