Remove the negative battery cable then the cables off of the starter then the bolts holding it on and work it out.new answerOn the 3.1 engine, you will definitely have to remove the oil filter and possibly the crank position sensor.
In the glove box
hire a mechanic
How do you replace starter on2.3 cy 1991 pontiac grand am
Replacing the starter on a 1991 Chevrolet Cavalier can be difficult for someone who has never worked on cars. The car first needs to be jacked up so that the starter can be reached. Then the wires will need to be taken off the starter and labeled so that they can be placed back on the new starter. The start will then then be taken off by removing the bolts. After the bolts are removed, the starter can be taken off and replaced.
Ask someone who knows about a 1991 Lumina 3.1 Euro or 'google' it!
Remove the transmission and starter. Unbolt the flexplate from the crank. While you're at it, replace the rear main seal. Replace the flexplate and torque bolts to manufacturer's specs.
you dont only a certified repair shop can handle R12
n ignition switch on a 1991 Chevrolet astro vanAnswern ignition switch on a 1991 Chevrolet astro van
how to add coolant to 1991 lumina?
The gas tank on a 1991 Chevrolet Lumina holds 17.1 gallons, and it takes regular unleaded fuel. The car comes with a 3-speed automatic transmission.
take it to the shop
The solenoid is part of the starter.
underneath engine, bolted on passenger side of engine,
The speed sensor on a 90 lumina 3.1 should be on the drivers side top of the tranny, below the steering rod. Sould be a screw in sensor with wires attached.
Remove fuel tank
my 1990 is doing same thing i dont know whats going on yet? have u figured yours out?
Disconnect the positive battery cable, and replace the starter. 2 bolts, a couple of wires , and replace it. It's just that simple.
Same answer as: "How do you replace a starter on a 92 Geo Prism LSI or GSI?" at this same site.
Disconnect the battery, locate the starter.. remove the mounting bolts, bring the starter down to where you can reach all of the wires going to the solenoid, and disconnect those.
Remove rear seat cushion and look.
its in the tank witch has to be droped
Should be able to access by removing inner door panel
no fuse check your anti-freeze level
You can probably just replace the muffler