Want this question answered?
Tape or zip tie it down....\
The plunger between the brake pedal and the switch is missing. The brake switch plunger is going through the hole with no connection to the brake pedal. Replace with aftermarket rubber stud and you should be fine. Costs about $3.00 and takes about 30 minutes to replace.
There is a brake light switch mounted high up on the brake pedal. The switch has a plunger which is released (extends) when you step on the brake pedal. This completes an electrical circuit. The switch has either come loose from where is it mounted so that the plunger is released all the time or part of the plunger has broken off. This has the same effect as having the plunger released.
the brake light switch is located on the arm of the brake pedal, above the pad. you will see a plunger-type switch that extends and retracts with the compression of the brake pedal. to replace it, unbolt it from the bracket attached to the brake pedal, disconnect the electrical connector, replace new part (compare the adjustment of the new switch with the old & adjust if necessary), connect electrical plug, mount new switch to bracket & test.
It is a plunger type switch screwed into the top of the transmission casing.
go buy a universal ignition key for it or replace the ignition switch, or lastly, replace the switch with a simple toggle switch. there should be some type of repair shop in your town, right? or do it the old fashioned way, hotwire the darn thing :)
Check the brake light switch. It is mounted high up on the brake pedal (has a plunger on the end). The plunger on the switch has either broken off or the switch has come loose from where it is mounted to the pedal.
you need to be more pasific buddy
The clutch safety switch keeps the car from starting unless the clutch is pushed in. On the top of the clutch pedal there is a little black box with a plunger on it. When the clutch is pushed in the electrical connection to the starter solenoid is completed. The switch just unscrews from the bracket.
The engine kill switch is under the seat.
The clutch safety switch is on the clutch pedal shaft. It is a small black box with a plunger coming out of it. When you push the clutch down, the clutch safety switch connects the starter and it should turn over. If it doesn't you may have to replace it or adjust it. It's adjustable. Just adjust it until the red plunger is fully retracted out of the switch when the clutch pedal is pushed in all the way.
Door plunger switch broken or bad.