well its easy look up your bum ya monkey!
how do you replace the valve cover gasket on a 2002 mitubishi lancer
In a 2004 Mitsubishi Lancer replacing the rear light bulb is relatively easy. First remove the plastic cover from the dome light. Unscrew the light bulb and insert the replacement.
In a 2005 Mitsubishi Lancer, the cabin air filter is located behind the glove compartment. To access it, you need to remove the glove compartment by unfastening the screws and gently lowering it down. Once the glove compartment is out of the way, you can find the cabin filter cover, which can be removed to replace the filter.
Underneath the plastic cover that has MIVEC written on it.
The cabin filter on a 2008 Mitsubishi Lancer is located behind the glove compartment. To access it, you need to open the glove compartment, then remove the stops or hinges to allow it to drop down fully. Once it's lowered, you can find the cabin air filter cover, which can be removed to replace the filter.
In a 1997 Mitsubishi Mirage coupe, the horn fuse is located in the fuse box under the dashboard on the driver's side. To access it, you’ll need to remove the cover of the fuse box. The specific fuse for the horn is usually labeled; refer to the diagram on the fuse box cover for identification. Make sure to check the fuse and replace it if it is blown to restore horn functionality.
To replace the water pump on a 1993 Mitsubishi Lancer, start by disconnecting the battery and draining the coolant. Remove the drive belts, timing belt cover, and timing belt if necessary, following your service manual for specific instructions. Take out the old water pump, clean the mounting surface, and install the new pump with a new gasket. Reassemble by reversing the disassembly steps, refilling the coolant, and checking for leaks.
You need to take off the cover from your engine and then you will see a plastic cover with aprox. 6 screws you need to take out those screws and under that you will see the spark plugs
To remove the steering wheel cover on a 1995 Mitsubishi Lancer, first, disconnect the negative battery terminal to prevent accidental airbag deployment. Next, use a flathead screwdriver to carefully pry off the plastic cover surrounding the steering wheel. Once removed, locate and unscrew the retaining screws for the steering wheel cover, then gently pull it off the steering wheel. Be cautious of any wiring connected to the airbag and ensure proper handling.
Yes. On the driver side of the engine bay, covered by a rectangular piece of plastic. The cover is approximately 10x8 inches.
Cam position sensor is in a mystical place called under your timing chain cover.... good luck
depends on how you take care of it. I have 155,000 on mine and have had no issues except for a leaky valve cover gasket which was fixed 60,000 miles ago.