Should be located in a removable housing at the engine end of the upper radiator hose Drain about 1 gallon of coolant from the radiator Remove this housing Note how thermostat is installed Clean both surfaces Replace thermostat and gasket Replace housing Re-fill coolant slowly to prevent an air lock Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level
how to replace a water pump on a 1991 acura legend
How do I put a alternotor belt on a 1991 Acura Legend
The thermostat is just under the throttle assembly at the front of the engine. You will need to remove a black plastic shield in order to access it. Is it difficult to remove and replace? Should that job cost $100? Would a failing thermostat cause the radiator to crack,leak and overheat on my 1991 Acura?
Yes, any C32A engine from 1991-1995 will fit in any other model/trim within that year range, with no modifications.
To replace the clutch disc in a 1991 Acura Legend you must first remove the engine from the vehicle. Loosen the pressure plate by adjusting the bolts and remove. Put the new one where the old one was and tighten the bolts.
Were are the timing marks on a 1991 acura legend
it sounds like the tranny reverse is gone and you have to replace the entire tranny
where do you install a new flasher for a 1991 Acura Legend?"
The map sensor for the 1991 Acura Legend is mounted on the firewall. It is in a box near the factory strut brace.
How do i pull codes for a 1989 acura legend
http://wiki.answers.com/Q/Where_are_the_fuses_for_the_1992_acura_legend_driver_and_rear_windows lokethed an the 1991 acura legend
On the steering wheel.