0
How do you replace a throttle position sensor on a 1993 Lincoln Mark VIII?
Wiki User
∙ 2010-04-02 16:34:53
follow the air induction to the throttle body. it is right behind it in front of the fire wall. good luck
I believe this model is the same as the 95. In that case, pull the throttle body off first. 4 8mm bolts and it is very easy to work on. You don't have to disconnect the accelerator cable, you can just move the TB to the side. There are 2 screws that hold it in place. You should also replace the gasket for the TB.
Wiki User
∙ 2010-04-02 16:34:53
Add your answer:
Earn +20 pts
How do you replace the throttle position sensor on a 97 Nissan altama?
how to replace the throttle position sensor on a 97 nissan altama
How do you replace a 2003 Kia Spectra throttle position sensor?
How to replace throttle sensor kia spectra 2003
How do you replace a throttle position sensor on a 2006 Nissan sentra?
you dont!
How do you change a throttle position sensor on a 1998 Bravada?
To change a throttle position sensor on a 1998 Bravada, disconnect the negative battery cable. Separate the wiring harness connector on the throttle position sensor and take off the sensor. Replace with new.?æ?æ
Where is throttle position sensor on 2008 dodge ram 5.7L?
It is a part of the throttle body. You have to replace the throttle body if faulty.
How do you adjust throttle position sensor?
There is no adjustment, they are electronic. You just replace them.It senses the position of the throttle and sends the information to the computer.
Where is the throttle position sensor in a 2005 Chevrolet Cobalt?
The throttle position sensor is in the throttle body.
How do you replace throttle position sensor in your 2003 Taurus?
The throttle position sensor, TPS should be in about the same position as it was in earlier models - so the "Related Question" below should also be helpful.
How do you replace the throttle position sensor in a 98 Olds intrigue?
The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.
What is the fuction of a throttle position sensor?
The function of a throttle position sensor is to monitor the position of the throttle in an internal combustion engine.
How does one replace the throttle position sensor on a 1998 dodge Dakota?
The throttle position sensor is on the drivers side of the throttle body. It is right in the middle with a connector hooked to it and two torx head screws holding it in.
How do you replace a throttle position sensor on a 2000 Pontiac Montana?
The throttle position sensor can be removed by dismantling the chassis in which it sits. This can be done by referencing the owner's manual f the Pontiac Montana.
