To replace the window regulator in a Ford falcon depends on the model, however the process is fairly similar. 1. Remove door trim (there should be some screws along the outside edges and behind the door handle) 2. Tape the door glass to the door or have someone hold it up as the next step will let it go. 3. Remove the two bolts that attach the door glass to the regulator. 4. Disconnect the power motor connector. 5. Remove the 4 bolts that hold the regulator to the door. 6. Remove the regulator and replace, perform all steps in reverse order.
HOW DO I REPLACE WINDOW REGULATOR MOTOR ON PASSENGER SIDE WINDOW
What question
how do I replace the passenger side window regulator on an E250, 2006. the window will not release to push to top of window frame only half way?
When replacing the regulator on a 2006 Ford Fusion, you need to follow the instruction on the manual so as to be able to replace the actuator on a 2006 Ford Focus with power window.
take the door panel off and unbolt the regulator and jam the window until you can replace the regulator
Window motor and regulator are found inside of the door panel and may be bolted or riveted in. Should be bolted. Disconnect the window from regulator, take out reg. and motor, then disconnect regulator from motor, reconnect new motor to regulator, reattach those inside of the door, then reconnect the window to the regulator, put it together and see if it works.
http://www.ford-forums.com/ford-ranger/11517-procedures-replacing-power-window-motor-ford-ranger.html Try this link.
Most likely will need a new actuator/regulator. (The scissor thing that winds the window up and down) I had to replace mine. Better to get them new, but I think the driver's side one is obselete now. You'll have to remove the trim on the inside of the door, remove the glass (it's held on by 2 little plugs), and replace it.
you can
You take the inner door panel off. Then, there is an arm that goes up and down called the window regulator. The glass is held in by hardware on the end of the regulator. If you get a used window from the salvage yard they will be able to tell you how to put it back in. Most of the time the window is separated from the regulator and the new window dropped in from the outside when the control handle is in the down position.
To replace the regulator on a 2006 Ford Fusion, you must engage a mechanic.
That would be EXTREMELY unlikely that any rear window regulator would fit in the front window, same side or not.