take apart and clean copper contacts, no need to replace.
how would remove brake light switch and replace on an 88 gmc
its right beside the wiper switch
To replace the headlight dimmer switch on an 87 Olds Delta 88 you need to open the instrument panel under the steering column. Next, remove the two screws holding the switch in place, remove old switch, and reverse directions to replace with new switch.
If the pump is working you will be able to hear it. Disconnect the hose at the pump and push the button on the wiper switch to make sure fluid is leaving the pump. If it is then the hoses must be checked all the way to the end of the wiper blades. If no fluid is present, you will have to replace the pump.
if its an 88 acura legend then you will need to remove the couple of bolts that hold it down and take it to the local auto store. like other cars you can just replace the bulb but on these acura you need to replace the whole headlight unit
To replace the ignition switch on a 1994 Oldsmobile 88, begin by disconnecting the battery to ensure safety. Remove the steering column covers to access the ignition switch, then disconnect the wiring harness and unscrew the switch from its mounting. Install the new ignition switch by reversing the removal process, ensuring it's securely attached, and reconnect the battery. Finally, test the new switch to ensure proper functionality.
To replace the ignition switch in a 1994 Oldsmobile 88, first disconnect the negative battery cable to ensure safety. Then, remove the steering column cover by unscrewing the screws and gently prying it apart. Locate the ignition switch, disconnect the wiring harness, and unscrew the switch from its mounting. Install the new ignition switch by reversing the steps, making sure to reconnect the wiring and test the ignition before reassembling the steering column cover.
To replace the ignition switch in a 1998 Oldsmobile 88, first, disconnect the negative battery terminal to avoid any electrical issues. Remove the steering column covers, then locate the ignition switch, which is typically mounted on the steering column. Disconnect the wiring harness and unbolt the switch, then install the new ignition switch by reversing the removal process. Finally, reassemble the steering column covers and reconnect the battery.
You have to remove the horn, steering wheel, retainer, turn signal switch, Ignition cylinder, and then upon removal of the upper steering column you will find the wiper switch attached to the upper steering column with a greased pin. The wiper switch also has to line up with the Hi Beam switch assembly upon re-installation. Tools needed will be a Steering wheel puller, a 13/16 socket with extension(or deep well), a Retaining plate removal tool (looks like a pickle fork with a bolt in the middle of it), pliers to remove the retaining ring, Phillips head screw driver, and torx bits
The replacement wiper blades will come with instructions on how to remove and install the wiper blades. Your owners manual should also have instructions if you don't follow the instructions on the replacement wiper blades.
To remove the ignition switch from a 1999 Delta 88, first disconnect the negative battery cable to prevent electrical shorts. Then, remove the steering column covers by unscrewing any screws or clips. Locate the ignition switch, which is typically attached to the ignition lock cylinder; disconnect the wiring harness and unscrew the switch from its mounting. Finally, replace the switch by reversing the steps, ensuring everything is securely reconnected.
on the 88 ranger the switch is above your rearview mirror located on the ceiling on the 88 ranger the switch is above your rearview mirror located on the ceiling