Want this question answered?
accessory drive not pully
how do you change seal on the accessory drive N14red top
to fix it drive to the dealer and trade it for a cummins so then you wont have that problem.
Accessory drive belt.Accessory drive belt.
Remove the air intake duct, if necessary. Refer to Air Cleaner Assembly Replacement in Engine Controls - 5.7 L. Install a breaker bar with hex-head socket to the drive belt tensioner bolt. Rotate the drive belt tensioner clockwise in order to relieve tension on the accessory drive belt. Remove the accessory drive belt from the pulleys and tensioner. Slowly release tension on the drive belt tensioner. Remove the breaker bar and socket from the drive belt tensioner bolt. Clean and inspect the drive belt surfaces of all the pulleys. Route the accessory drive belt around all the pulleys except the water pump pulley and tensioner. Install a breaker bar with hex-head socket to the drive belt tensioner bolt. Rotate the drive belt tensioner clockwise in order to relieve tension on the drive belt tensioner. Install the accessory drive belt under the water pump pulley. Install the accessory drive belt onto the drive belt tensioner. Slowly release the tension. Remove the breaker bar and socket from the drive belt tensioner bolt. Install the air intake duct, if necessary. Refer to Air Cleaner Assembly Replacement in Engine Controls - 5.7 L. Inspect the accessory drive belt for correct alignment.
Loose accessory drive belt, faulty accessory belt tensioner (if applicable).
The serpentine belt would be the same as the accessory drive belt.
12.5 - 17 mpg depends how you drive
I think you mean the Supercharger belt? You cannot drive anywhere without your accessory belt... You can drive as long as you want without your Supercharger belt but be prepared for a substantial loss in power.
V Belt and Serpentine Belt.
Disconnect the battery. Remove the air temp sensor, air filter hose, and accessory drive belt. Drain the radiator and remove the hoses from the water pump. Remove the distributor cap and rotor, and replace with new ones.
3/8 breaker bar or wrench into square hole in idler arm twist in direction that realeases tension on belt and remove.