0
How do you replace an O2 sensor on a 1995 Chevy S-10 4.3 liter CPI Vortec engine?
WannaBeMechaniCarl
If you are installing a new one I would unplug the wire harness to the bad sensor and then cut the wires off at the sensor. This allows you to slip a 7/8" box wrench over the sensor to break it loose and remove it. Install the new one and tighten it with a 7/8" open end wrench and plug the harness back in. Tighten it as you would a spark plug.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Can a bad camshaft sensor in a Chevy vortec engine cause a no start?
It sure can.
Does a crank sensor have anything with starting on a 96 Chevy vortec?
if the crank sensor is bad it does not tell the computer that the crank is turning it will not fire up the engine.
Where is the IAT sensor on 2006 Chevy 5.3 Liter vortec engine?
Its together with the mass airflow sensor(maf). On the top of the air intake tube.
Are the heads on a 1992 Chevy 350 vortec or not?
No, the 1992 Chevy 350 (5.7L) V8 is not a Vortec engine.
Where is coolant temp sensor on 2000 Chevy s10 blazer with 4.3 vortec engine?
Drivers side of engine, between the #3 and #5 spark plug.
Where is the throttle position sensor on a 2001 Chevy Tahoe with Vortec engine?
It is on the lower right hand side of the throttle body. There are 2 sensor on that side , it is the lower one.
How much torque for a 97 Chevy Z71 350 vortec engine?
how much torque for a Chevy Z71 350 vortec engine valve cover
Where is the knock sensor located on a 2003 Chevy Tahoe 5.3 l vortec?
That engine has 2 of them and there underneith the intake manifold. You will have to remove the intake to get to them.
Where is the oil sending unit located on the 2001 Chevy 4.3 vortec engine?
Where is the oil sending unit located on the 2001 Chevy 43. vortec engine?
Where is the temperature sensor on a 96 350 vortec Chevy Tahoe?
In the font
Where is the throttle position sensor on a 2003 Chevy Tahoe with Vortec engine?
It is the bottom sensor on the right side of the throttle plate housing. That is the part that all the duct work comes from the air filter box and hooks to the engine is.
Will a motor out of a 92 Chevy 1500 work in a 96 Chevy 2500 Both are 5.7 one is throttle body one is VORTEC?
No it will not. The 96 vortec has a crankshaft sensor and alot of other sensors on the engine that is required so the transmission will work that will not interchange with the 92 engine. Even the fuel pump would have to be changed. You must put a VORTEC engine back in the 96 so everything will work correctly.
