0
Where is coolant temp sensor on 2000 Chevy s10 blazer with 4.3 vortec engine?
Wiki User
∙ 13y ago
Drivers side of engine, between the #3 and #5 spark plug.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is the engine coolant temperature sensor on 2002 v-6 vortec motor Chevrolet blazer?
It is on the right head beside the back spark plug.
Where is the maf sensor located on a 1995 Chevrolet Blazer with a vortec engine?
Apparently, there is none. They started using them in 1996.
Where is the coolant temp sensor located on a 91 4.3?
Should be on the front of the engine block, if you have a vortec it is on the lower maifold below the EGR valve.
How would warmer weather make your 94 blazer v6 vortec act like its loading up and running rough as if running on 5 cylinders?
Engine coolant temp sensor could be faulty, the one close to the thermostat housing with two wires plugged into it.
Does a 1992 blazer 4.3 vortec engine have a timing chain?
Yes.
What is blazer vortec?
Vortec is the motors name in the blazer and it is a great motor
Where is the crankshaft position sensor on a 1994 Chevy blazer 4.3 vortec?
It is bolted to the side of the timing cover right behind the harmonic balancer. That is the bottom pulley on the front of the engine.
How many quarts of oil does a Chevy blazer with a 4.3 liter vortec engine take?
A Chevrolet Blazer with a 4.3 liter vortec engine will take approximately 6 quarts of oil. The recommended type of oil is 5 W 30.
Where is the crankshaft position sensor on a 1994 Chevy blazer 4 wheel drive 4 door 4.3 vortec?
Lower front of engine, behind crankshaft balancer, best accessed from underneath.
Where is the ECM located on a 2001 Chevy Blazer 4.3L Vortec?
It's located on the coolant reservoir on the passenger side fender well.
Where is the location of the engine coolant temperature sensor on a 1995 Chevrolet S10 Truck V6 4.3 liter Vortec engine?
Passenger side, side of cylinder head next to sparkplug, single wire sensor, needs offset 13/16 wrench to remove it.
Where is the map sensor located at on a 1994 S10 Blazer 4.3 vortec?
The manifold absolute pressure (MAP) sensor is an important component to your 1994 General Motors Blazer/Jimmy's EFI system. This pressure sensor is located provisioned into the intake manifold assembly.
