Want this question answered?
If you know where to put the key in, you know where the ignition switch is... Actually, safe to say you should stay away from it.
Remove the retaining ring from the top of the ignition switch. Pull the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
Here is a link to an illustrated step-by-step procedure for replacting a Vanagon ignition switch: http://carboncow.net/vanagon/projects/ignition_switch.htm
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
how do you install new ignition switch on 1989 chevy G10 van?
I would look for a blown fuse. Make sure ignition switch returns completely to the run position, after starting.
how can you start a '89 mercury cougar with a broken ignition switch?
you have to remove the steering wheel and the turn signal. this requires special tools that can be purchased or rented cheaply.
On the interior firewall to the left of the steering column
My 1994 Bronco will do this due to a bad positive connection on the starter (corrosion and dirt) when i clean it and spray some PB Blaster it gets a better connection and starts fine.
i found it totally easier to by-pass the switch than to try to repair it just cut it and splice , i did and its been perfect since