Best Answer

The ignition swithch is on the steering column about 18 inches from the floor and is held by 2 screws.

User Avatar

Wiki User

โˆ™ 2015-07-15 19:41:12
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: How do you replace an ignition switch on a 91 Chevrolet S10?
Write your answer...

Related Questions

How do you change the ignition switch on a 1989 Chevy Blazer S10?

You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.

Cost to replace timing belt on s10?

The Chevrolet S10 doesn't have a timing belt.

How do you change ignition switch in 95 S10?

help help

How do you replace the ignition switch in 1996 S10 Chevy pickup?

Remove cowling from under the steering wheel, remove the two nuts holding the wheel coloum. Drop the steering coloum. Ignition switch is about a foot down on the left side. Unhook the wires remove switch replace. P.S. Unhook battery cables high voltage in ignition system.

Why S10 gauges go out starter will not work?

check your ignition switch.

No brake lights on 93 Chevrolet S10 you have replaced bulbs fuse and switch?

blinker switch is part of that system is most likey problem trust me i owned 9 s10 all 82-94 and college for 5 years of elec/auto replace the blinker switch on the clolume"

Cost to replace timing gesr on 1996 Chevrolet s10 4.3?

cost to replace timing gear on 1996 chev s10 4.3

What is the ignition timing on a 1988 Chevrolet S10 Blazer 2 8 liter engine?

10 degrees

What degree do I set the ignition timing for 1987 Chevrolet S10 2.5L 4cylinder?

See underhood sticker.

Is there a inline fuse from ignition to starter on 1995chevy s10 blazer?

starting at the ignition switch going down the steering column. Next is an ignition switch. from there it goes to the selinoid. Inbetween the celinoid and the ignition switch, just above the celinoid is two fusable links.

Where do you find the ignition switch on the Chevy s 10 blazer?

It depends on what year S10 you have.

How do you replace heater core in S10 Chevrolet?

you have to take the dash's a big project.

Chevrolet S10 only driver side front blinker not working?

Replace the bulb.

How do you replace the evaporator coil on a 1995 s10 Chevy pickup?

take to your chevrolet dealer

Where is the oil pressure switch located on a 1993 Chevrolet S10 pickup?

oil filter housing

Where is the cut off in the Chevrolet s10 93?

If you are looking for a fuel inertia switch, it doesn't have one.

How do you replace an ignition switch on a 1987 S10 stick shift?

The ignition switch is on the lower part of your steering column. Not very easy to get to but you can lower the steering column to get a better look at it. there should be 2 switches down there that have bars running to them. one is the headlight brights switch, you should be able to click the brights and see what switch you need to replace. there are 2 screws that hold the brights switch in place. you need to remove that switch first, then there are 2 more for the ignition switch. After that you just turn the switch on the bar to get it to remove. hope this helps, its not a hard job to do just hard to get to. Good luck :)

How do you set the clock on 1986 Chevrolet S10 pickup?

Turn radio off. Turn ignition switch on. (engine not running). Pull OUT seek button to change hours. Pull out scan button to change minutes.

How do you replace the hydraulic clutch line on a 1997 Chevrolet S10 pickup?

how do you replace hydraulic line on a 1997 s-10

Where is the inertia emergency fuel shut off switch on a 2002 Chevy s10?

Chevrolet does not use an inertia fuel shut off switch.

How do you override a neutral safety switch on a 1995 Chevy s10 blazer?

You do not ,you replace it .

How do you replace a speedometer cable on a Chevrolet Pickup S10?

You didn't mention what year the S10 is but, yours probably doesn't have a cable driven speedometer. It is electronic.

Carburetor componets on 2002 Chevrolet s10?

The 2002 Chevrolet S10 was fuel injected.

How do you install key ingition switch 1988 Chevy S-10?

how do install key ignition switch 1988 Chevy s10

Is there a starter swith on s10 95 chev?

You have a starter/ignition switch mounted in the steering column and you have a starter solenoid switch that is mounted to the starter.