Want this question answered?
ill smash your back doors in.
You can now order a well-designed front bumper form online stores like BumperOnly and they will ship the product along with installation material and guide with it. You can easily follow the instructions and replace the bumper yourself.
You remove the bolts holding it to the car frame or chassis. Lay your beach towels out under the bumper area and lay downn on your back. Look up. This is all I can do.
Is this the side marker or is it in the bumper, to replace the light in the bumper, you need a Philips screw driver, and on the inside side of the light, there is a little hole in the bumper, stick it in and loosen the screw. After that the lens should come right out and you just need to twist the fixture and the bulb will come out the back. after that the bulb can be pulled out of the connector and tah dah... Is this the side marker or is it in the bumper, to replace the light in the bumper, you need a Philips screw driver, and on the inside side of the light, there is a little hole in the bumper, stick it in and loosen the screw. After that the lens should come right out and you just need to twist the fixture and the bulb will come out the back. after that the bulb can be pulled out of the connector and tah dah...
For us, we had a problem with the front bumper so I guess the back should be the same. The dealer was charging us around $1000 for a new bumper and labor. Online sites showed the bumper for around $300. I ended up doing it myself and saving $700.
To replace a Pontiac Grand Am bumper cover, start by taking out either the three bolts on the side of the fender or in front of the wheels. Remove the top pushpins to remove the cover. Push back the two pins for each headlight, and pull them up. Unplug the lights. Then, get the replacement bumper, and snap it into place like the previous one.
The rear bumper cover is held onto the frame by 4 bolts. They have a 13 mm head, and are accessed from under the van. They thread directly into the back of the bumper cover, therefore no nuts to worry about. The rounded edges of the bumper cover slide over a pin, so when the 4 bolts are removed, the bumper cover can be pulled straight off.
The car's bumper protects it's front and back ends.
You have to remove the front bumper and remove the head lamp. then two plastic covers on the back of the assembly.
You have to remove the front bumper and remove the head lamp. then two plastic covers on the back of the assembly.
Perform the 'bounce test' by placing a hand on a corner of the car bumper and pushing down as hard as you can. The bumper should bounce up once and settle back down again with no further bouncing.
Democrats put it on the back bumper and Republicans put it on the front.