Want this question answered?
How to replace a brake light on a nissan Tiida hatch back.
On a 1989 Acura Integra hatch back the brake lights are reached through the hatch itself. The brake lights housing are on the rear of the vehicle. Unplug the bulbs and replace them.
You have to open the rear hatch like you would to replace the reg. brake lights. Screws should be accessible once hatch is fully open.
Just disconnect the negative cable from the battery.
you have to open the hatch, take all the plastic interior apart, just to get to your bulbs. its a pain.
The brake lights are accessed through the rear hatch. Find the panel on the rear sides of the car. Pop out the panel and access the brake lights. Replace the bulbs.
Open the hatch - remove the protective cover from the housing - twist out the bulb holder - remove and replace bulb - re-install in the reverse order.
My 94 laser has an anchor near the latch for the hatch
If it is an interference engine and the belt breaks, serious engine damage will occur. Replace the belt according to the recommendations of the manufacture.
The rear brake lights on a 1995 Honda Civic can be reach vial the rear hatch. Open the hatch in look for the plastic cover for the rear lights. Remove the cover to reveal the light plugs. Pull and replace the bulbs.
Lift the rear hatch you will see 2 torx screws. Remove the screws and slide out the lens. remove corresponding bulb/socket, replace and reinstall.
Open the rear hatch there are 2 screws on the inside edge of the tail light remove them then remove the light housing. Unscrew the plug at the back and replace the bulb. Good Luck James