The trick here is removing the plastic tail light assembly after you've removed the obvious screws holding it in place. Once these screws as removed, you would expect the assembly to just come off but it doesn't. DO NOT PULL DIRECTLY OFF! There as screws still holding the assembly in place. You need to shift the assembly to the side (slide right on passenger side, left on driver side). The assembly will slide slightly and you should be able to remove it at this point. You see there are plastic holders where the the head of the screw fits through and then slides to a narrower section to hold it in place. If you don't slide before you pull, you'll break the plastic tabs. At this point, it simple to replace the bulb and replace the assembly.
To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.
From inside the trunk.
y
replace sensor when pad repacement is done
take screws out of lense and pull bulb out.
video on how to replace parking brake cable in ford escape 2003
There is a campaign on the brake bulbs for 2000-2003......If it hasn't been done you should get it done. The bulbs and sockets will be replaced.
they are two different lights. replace the light that is malfunctioning, but check the fuses first. It's the cheapest way out.
at the lower 2.98 mm at center 596.0
The 2003 Kia Sorento has 24 valves.
The 2003 Kia Sorento has a V6 engine.
where is the pcv valve on a 2003 kia sorento