0
Jack front of car, remove both wheels/tires, be safe and put jack stands under-neath vehicle. There are two bolts holding calipers in place, you will need an hex-shaped socket to loosen and tighten them. Pull calipers out, removed old pads install new ones being careful to match the correct ones to each side of the caliper, you will need a special tool to push the caliper piston back in, you will need to carefully pop off the master cylinder cap just enough to let some air out when you reset piston caliper in. Special tool can be found at any auto parts store. Reverse procedures on installation. Don't forget to torque you wheel lug nuts.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What kind of brake fluid for a 1996 Dodge Avenger?
Dot 3
How do you get a thermostat unstuck on a 1996 dodge avenger?
replace it. when they go bad you can't fix them.
How can you remove the dash board on a dodge avenger?
Ask a Loacl. HOW do you remove the dash board on a 1996 dodge avenger
How do you replace the drivers side door handle on a 1996 dodge avenger?
Remove the inside door panel from your 1996 Dodge Avenger. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install your new door handle.
Wiring Diagram for a 1996 Dodge avenger?
i have a 96 dodge avenger 2.5 and it keeps blowing my ignition switch. any idea why?
Can you use a front bumper from a 96' Mitsubishi eclipse or Chysler sebring for my 96' Dodge avenger?
You can use the front bumper for a 1996 Chrysler Sebring on a 1996 Dodge Avenger.
Does a 1996 Dodge Avenger have an Automatic Transmission?
Most of them did have the auto.
What is 1996 dodge avenger thermostat temperature rating?
195
Where is the brake light switch on a 1996 Avenger?
It is underneath the Brake Pedal.It's mounted to and right above the brake pedal.
Where is the check engine light on a 1996 dodge avenger?
The dashboard dude
Where is the Fuel pump kill switch on a 1996 dodge avenger?
Dodge does not use inertia or kill switches.
How do you install a ball baering in a 1996 dodge avenger?
What ball bearing are you referring to?
