The cover comes off with easy prying on the side of the plastic case over the assembly. Then, the bulbs holder comes out with a slight twist. The bulbs can then be pulled from the bulb holder.
In order to change the brake light, check your manual for directions. You will need to remove the cover and replace the burnt out bulb.
Remove the tail light assembly cover in the cargo compartment. Take hold of the brake light connector. Push the connector in and turn at the same time. Do the same with the brake lightbulb. Reverse the process to install the new brake lightbulb.
it happened to my 2003 kia sedona it was the alternator it was not chargeing need to be replaced (very long time to replace like 6.5 hours) had shop do it
possibly have a brake light out
The spot to connect the remote starter parking light to the brake wiring in a 2002 Kia Sedona is just above the brake pedal.
I am looking for the bulb number to replace a burnt out bulb on a 1991 Toyota pickup
if its burnt out, replace it, if not, check the wireing
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
How to replace a brake light on a nissan Tiida hatch back.
low on brake fluid top off
You need to have the engine and brake systems checked for codes. See related questions below.
To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.