Want this question answered?
How do you replace a mower deck belt on a stx38 hydro
Use the deck removal rod to take tension off mowing deck power belt. Re move guard covering pump pulleys. Remove bolt holding electric clutch to engine output shaft. Loop belt around pump pulleys, between idler pulleys, and over crank pullley. Align shaft key inside e clutch and reassemble. Pretty easy once you get the shaft key lined up.
Disingage the mower deck take off the mower deck look under neath their and replace the belt
One should always consult the owner's manual before attempting such a procedure. To replace the drive belt, one must first remove the mower deck. Then remove the old belt and belt guides. Follow the belt threading diagram on the underside of the tractor to place the new belt on the tractor. Replace the belt guides and the mower deck to finish.
i need diagram on how to replace deck belt on John Deere GT235 mower
At one of my sites; link below:
best buy
if you remove the deck, easy quick release front and rear, you will have direct access to the drive belt under the mower
You will need to remove the cutting deck to get to the blades. Here you will find the drive belt, which you just slip off.
The belt is too loose. Replace it or adjust the idler.
remove the drive pulley, slip the belt on, then down through the frame onto the idlers that the pedal controls... done..
Could vary depending on year. Mine is a B141 at 143.5" Note fit is tight and one blade pulley must be removed to install.