0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Do you have to remove the distributor to replace the ignition coil on 1990 Toyota Camry 4 cylinder?
No. The coil is the piece at the other end of the wire that comes out of the center of the distributor cap.
How do you replace the antenna on a 1992 Toyota Previa?
Most antenna in cars can just be unscrewed at the base. You may have to disconnect a wire at the base though. Check your owner's manual or a car repair manual for more details.
What terminal in diagnostic plug is for tachometer on 1991 Toyota Camry?
the black wire that comes out of the distributor
When is it recommended to replace a distributor cap and wire set for a 1993 Ford 4-cylinder?
75,000 miles
I had my catalytic converter replaced in a 1993 Toyota Previa why would the check engine light still be on?
hey man all you have to do is earth out the cat wire and problem solved ,you will have two or one wire comming from the cat , hope this helps
The door locks are stuck and clicking on a 94 Toyota Previa is this a fuse which one?
could be a short in the lock switch ,or there is a short in the door wiring some wire its binding with metal some where
How do you change distributor on Toyota previa?
Remove the heatshield (kind of triangle shape w/ 3 12mm bolts, slide it rearward out of the way. Label each of the 5 wires to ensure correct installation later. Pull out the locking tab of the boot & unlock it from the cap. Then gently pull the wire out of the cap holding the gasket part, not the wire itself to protect it. Use a 7mm socket & long extension to remove 3 bolts securing the cap and remove it. Use a scewdriver to remove 2 screws atop of the rotor & pull it straight out. Save the screws for installation of the new rotor. Install new rotor, cap, & 5 old wires in reverse order. Note that there's an O-ring between distributor & cap to seal out moisture; replace it if damaged. Also if oil is found inside the distributor, it's shaft's O-ring has failed. The whole distributor needs to be remove to replace this shaft's O-ring.
How do you replace the front and rear window wiper assembly on a 1993 Toyota Previa and how can you keep them rust free?
I'm unsure how to replace the arms on the Previa, mine is a 92, but here is what I did. The washer nozzles are built into the wiper arms so I figured they would be expensive and difficult to replace since they were rusted I wanted to do something. I just used a wire wheel on them to know the rust off. Put some newspaper under the arms and used some Rustoleum flat black paint. Looks pretty much new and it was under 5 bucks. Hope this helps
Will a 1.60i Toyota cluster fit in a 1.3 Toyota tazz?
Apparently it will work. There is however one wire that needs to be switched on the plug which fits into the back of the cluster. This is the wire which comes from the distributor for the rev counter. Have not yet tried it though. need to still connect it up.
How do you change spark plug wires and distributor cap 1999 dodge stratus?
there is no cap it has a coil for each plug wire on the motor remove one wire at a time and replace it
How do you replace the passenger side mirror on 2001 Toyota Sienna?
The passenger side mirror on a 2001 Toyota Sienna is mounted by screws. To replace the mirror remove the mounting screws and unplug the wire clip.
How do you change wire?
Spark Plug Wires? Remove them 1 at a time from the spark plug to the distributor or the ION pack, remove and replace the spark plug, add the new spark plug wire from the newly added spark plug to the distributor or ION pack.
