Gain access to the back of the console and screw the retainer back on to the receptacle.
open center console take insert out reach in and pop out cupholders and replace
To change the map light in a 2005 Town and Country, first lower the sunglass holder. Remove the single screw holding the console and firmly pull down the entire console from the rear. It will release the two clips allowing the entire console to be removed and the map light can be changed.
Bottom left of dash under steering wheel locate sunglass holder, open holder and then pull up fusebox underneath
Remove the screws that fasten the console to the floor, there are 2 in the rear cupholder, 1 in the front cup holder, and 2 near the shifter (where the console seperates). When all the screws are removed you can lift out the console (be careful to unplug speaker wires), turn over, and remove the speaker.
Very carefully(;
How do you replace cup holder in a 2000 Lexus ES300
If I remember correctly, you really can't, it's part of the console so the whole console has to be changed.
To replace a bulb in the center console of a Mercedes CLK W208, first, ensure the car is turned off. Carefully pry off the trim surrounding the console using a plastic trim tool to avoid damage. Once the trim is removed, locate the bulb holder, twist it counterclockwise to release it, and replace the old bulb with a new one. Finally, reassemble the trim and ensure everything is securely in place.
I believe the tissue holder goes to the right of the console on the passenger side.
Depends on what year the xj is and if your talking outside rear view or inside. I just replaced my inside rear view. It's auto-dimming. If it's the inside and auto-dimming, there is a cap on the top of the mount. Carefully pry back near the top and this peice should come off easily. You should then be able to push the mirror post straight down to release it from the windshield mount. Then you'll have to loosen the overhead console. Do this by using a straight blade screw driver to turn the plastic keeper screw, that is is visible with the sunglass holder open, 90 degrees counter-clockwise. Pull gently, slightly downward and toward the rear of the car. The overhead console is held in the front by two metal tabs so there are no more screws. That will free the overhead console and you can see the wiring harness for the mirror toward the front of where the console was. The connector has a tab so very carefully lift the tab and pull apart the harness. Re-attach in reverse order and you'll be seeing things in the rear of the car again! Hopefully not flashing lights!
there are little screws and clips