Dodge Dakota

How do you replace door panel speakers on 1997 dodge Dakota?

616263

Top Answer
User Avatar
Wiki User
2011-09-12 20:49:08
2011-09-12 20:49:08

When I changed my door speakers I simply removed the 3 screws on the bottom of the panel, one up near the side view mirror, and when you pull the door handle open there is a T- screw in there. After that you simply lift straight up. The panel should separate from the door and give you enough room to replace the speaker. Note I have no power windows or door locks so I didn't have to worry about those wires, and I left the bar that connects to the door handle on as well. I had plenty of room. Hope this helps

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

On a 1997 Dodge Dakota, the factory amplifier is located in the passenger side kick panel, directly in front of the door. The amplifier should be hooked directly into the speakers.

User Avatar

Yes, there is a fuse panel diagram for a 1990 Dodge Dakota. It is found on the back of the panel cover and it can be found in the owners manual.

User Avatar

link here: http://www.craigcentral.com/durango/speakers.asp

User Avatar

replace the headlight switch its wore out replace the headlight switch its wore out

User Avatar

remove door panel, roll down window 1/3, unbolt from track

User Avatar

To replace the back speakers in a 2006 Acura TL, remove the SRS housing on both sides and the back panel of the speakers. Remove all wiring attached to the speakers and replace.

User Avatar

Front speakers are in the door. remove screws on the door panel, then remove the panel and you'll see the speaker

User Avatar

Under hood on driverside inner fender.

User Avatar

The fuse diagram on a 1994 Dodge Dakota is located on the inside cover of the fuse panel. It details the location and function of each fuse.

User Avatar

Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.

User Avatar

it is the plastic panel to the left of your feet on the drivers side and to right side of your feet on the passengerside.

User Avatar

Yes the door panel must be removed to gain access to the speakers. Just replace them It will sound better.

User Avatar

It is in an owners manual available from MOTORLIT.COM.

User Avatar

Which speakers and which moulding exactly are you refering to? If you are talking about the door speakers: Just remove the screws on the panel and inside of the door handle and inside of the armrest on the door there is a screw. Then you must remove the door handle by using a screwdriver to pry off the clip behind the door handle. After that just pop the panel off.

User Avatar

Should be on a panel under the dash undernieth the instrument cluster.

User Avatar

Remove the back seat with a number 55T torque screw socket and then you can slide out the back panel to get to the speakers.

User Avatar

In order to replace the speakers you have to flip down the rear seats and look at the screw ports and remove all the screws to remove the panel covering the speakers. The rest is self explanatory.

User Avatar

Remove door panel, remove 4 screws, remove speaker, put new speaker in, replace screws, replace door panel. Done.

User Avatar

Pull off the door panel, unscrew the stock/old 6.5 inch speaker, disconnect the speaker wiring and connect the new speaker. Screw the speaker in the hole in the door and replace the door panel.

User Avatar

They are located in the front doors, near the kick panel. They are in the same location they were throughout the car's history. There are no rear speakers factory installed.

User Avatar

Not sure what you are asking, but a 1992-1993 would be similar.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.